know which pin on the OSD board you need / want to use for pack voltage and where that pin is actually located on the OSD board
#MINIM OSD V1 1 MOD#
know which hardware board you have, example KV team mod I am not an expert on OSD, but several things need to be correct: It'ld be great if you could help me fixing this What did I make wrong? Is there something else I can check?
As mentioned above, I measured the correct voltage at these contacts. Secondly, the battery voltage shown to me through the OSD is always 0.0V. The problems I still have are two, whereof at least one drives me crazy.įirstly there's a slight ghosting of bright areas, which I deem not to be that distracting when the drone is in action. When the system is powered, I can measure the correct battery voltage between the Bat1 + and ground on the board. I made a direct connection between the Bat1-ground on the board to the CC3D connected ground. I configured it according to:įirmware: LP_MicroKvteam_CC3D_analog_inputs1708.hexįlight Controller: CC3D (dunno whether it's a revo, seems somehow customized in that orange box) with LibrePilot 15.09Įverything is wired according to the documentation, except for the battery ground. I ordered an MinimOSD Micro KV Team Mod, which also is lots of smaller and less heavy. Based on my understanding of the board layout, that divider is unnecessary, as there are the necessary resistors already present on the v1.1 board.
I also tried a voltage divider (22 kOhm & 1,5 kOhm) to ensure the voltage output is between 0.0V and 1.1V.
I added an OSD (MinimOPOSD v1.1) which worked fine, but it always showed 15.33V. I did soon realize that something important is missing: Knowing the battery voltage. Some time ago I bought a drone, a Sky Hero Anakin Club Racer 6". According to what I found on the internet, everything is done right. However, I have reached a point, where I am stuck without assistance. I am new to this forum and tried, up to now, to solve all issues on my FPV journey based on existing articles.
0 kommentar(er)
